Menu
Your Cart
Welcome to the new Robomaa online store!

Motor Driver HAT for Raspberry Pi, I2C Interface

Motor Driver HAT for Raspberry Pi, I2C Interface

Description: The Motor Driver HAT is designed for Raspberry Pi, controlled via I2C interface, will drive two DC motors at the same time. It's an ideal choice for you to DIY mobile robots. Comes with RPi screws x 2.

Features:

  • Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards
  • I2C controlled, by setting 5 address jumpers, it is stackable up to 32 this modules
  • Onboard PCA9685 chip, provides 12-bit hardware PWM to adjust motor speed
  • Onboard TB6612FNG dual H-bridge motor driver, high efficiency, low heating
  • Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal
  • Reserved I2C control pins, allows to work with other control boards
  • Comes with development resources and manual (examples in BCM2835, wiringPi, and python)

Specifications:

  • Power supply: 6V~12V (VIN terminal)
  • Logic voltage: 3.3V
  • PWM driver: PCA9685
  • Control interface: I2C
  • Motor driver: TB6612FNG
  • Dimension: 65mm x 30mm
  • Mounting hole size: 3.0mm

WIKI: http://www.waveshare.com/wiki/Motor_Driver_HAT

Write a review

Please login or register to review
None
20.80€
Ex Tax: 16.77€
Cookies
We use cookies to improve your browsing experience and the functionality of our site. These cookies are required for the website to run and cannot be switched off. Such cookie are only set in response to actions made by you such as language (En/Fi), currency (EUR) and login session id which is set by system (OCSESSID). You can set your browser to block these cookies but our site may not work then. Google Analytics (GA4) cookies allow us to measure visitors traffic and see traffic sources by collecting information in data sets. They also help us understand which products and actions are more popular than others. We do not share these information with Google.