Brand: Sparkfun
Model: SEN10264
Description: A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor increases. Patented technology by Spectra Symbol - they claim these sensors were used in the original Nintendo Power Glove. I love the Nintendo Power Glove. It's so bad!
The resistance of t..
10.90€
Ex Tax:8.79€
Brand: Sparkfun
Model: SEN11207
Description: This is a piezoresistive force sensor. The harder you press, the lower the sensor's resistance. Pressing hard, the resistance changes from infinite to ~50k. The sensor itself is thin and flexible, but the resistance does not change while being flexed. Resistance changes only when pressu..
28.20€
Ex Tax:22.74€
Brand: Sparkfun
Model: 09375
This is a force sensing resistor with a round, 0.5" diameter, sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR its resistance will be large..
11.00€
Ex Tax:8.87€
Brand: Sparkfun
Model: 09673
This is a small force sensing resistor. It has a 0.16" (4 mm) diameter active sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR, its resista..
10.00€
Ex Tax:8.06€
Brand: Sparkfun
Model: 09376
This is a force sensing resistor with a square, 1.75x1.5", sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR its resistance will be larger t..
13.00€
Ex Tax:10.48€
Brand: Sparkfun
Model: 09674
Description: This is a very long force sensitive resistor - over 2 feet - has a sensing area of 0.25x24". This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FS..
20.20€
Ex Tax:16.29€
Brand: Sparkfun
Model: SEN10245
Description: This load sensor is the same one found in digital bathroom scales (you know, the ones you use in January for your New Year’s resolutions, and then forget about a month later). This sensor can measure up to about 110 pounds. Check the video below for a simple explanation on how these wor..
12.90€
Ex Tax:10.40€
Brand: Sparkfun
Model: SEN13879
Description: The SparkFun Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. By connecting the amplifier to your microcontroller you will be able to read the changes in the resistance of the load cell, and with some calibration..
13.90€
Ex Tax:11.21€
Brand: Sparkfun
Model: BOB13878
Description: The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. If you open up an electronic bathroom scale, you’ll find a large rat’s nest of wires. The Load Sensor Combinator was created to combine the 12 wir..
2.60€
Ex Tax:2.10€
Showing 1 to 9 of 9 (1 Pages)