This synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 5 V with an available outp..
The Tic T500 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our fre..
The Pololu G2 high-power motor driver is a discrete MOSFET H-bridge designed to drive large brushed DC motors. The H-bridge is made up of one N-channe..
The 4D Programming Cable is a USB to Serial-TTL UART converter cable. It incorporates the Silabs CP2102 USB to Serial UART bridge IC (as used in the u..
The SK-43PT-PI is a starter kit for the uLCD-43PT-PI and includes all of the components needed to immediately get started with the uLCD-43PT-PI. The k..
INTRODUCTION: This AL Heat Sink(With adhesive tape) and a U.S. made 3M-8810 thermal adhesive tape on the back of the heatsink. So you don't require a ..
Description: Raspberry Pi Camera Cable FFC 60cm. This cable is 600mm long We have cables in 50mm, 100mm, 200mm and 300mm so you can have the perfect f..
Description: This is a camera module (without driver PCB) compatible with the official Raspberry Pi Camera Board V2, with 8-megapixel IMX219 sensor an..
We use cookies to improve your browsing experience and the functionality of our site. These cookies are required for the website to run and cannot be switched off. Such cookie are only set in response to actions made by you such as language (En/Fi), currency (EUR) and login session id which is set by system (OCSESSID). You can set your browser to block these cookies but our site may not work then. Google Analytics (GA4) cookies allow us to measure visitors traffic and see traffic sources by collecting information in data sets. They also help us understand which products and actions are more popular than others. We do not share these information with Google.