Brand: Pololu
Model: Micromotor992
Overview
These tiny, high-quality motors are intended for use at 6 V. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range. Lower voltages might not be practical, and higher voltages could start negativel..
19.33€
Ex Tax:15.40€
Brand: Pololu
Model: POLO/1101
Overview
These tiny, high-quality motors are intended for use at 6 V. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range. Lower voltages might not be practical, and higher voltages could start negativ..
19.33€
Ex Tax:15.40€
Brand: Pololu
Model: Micromotor1097
Overview
These tiny, high-quality motors are intended for use at 6 V. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range. Lower voltages might not be practical, and higher voltages could start negativ..
19.33€
Ex Tax:15.40€
Brand: Pololu
Model: POLO/997
Overview
These tiny, high-quality motors are intended for use at 6 V. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range. Lower voltages might not be practical, and higher voltages could start negativ..
19.33€
Ex Tax:15.40€
Brand: Seeedstudio
Model: MOT102A2B
Description
Gear (reduction ) motor, made in Shenzheng, China. Pretty good quality, running a speed at 60 rpm. All you need to do is connect the postive and negative pole-pin, simple enough for beginners.
Specifications:
Voltage: 2.4V
No Load: 55 rpm - 30 mA
Maximum Efficiency: 40 rpm ..
19.33€
Ex Tax:15.40€
Brand: DFRobot
Model: FIT0094
Introduction
This motor has a long (0.365" or 9.27 mm), D-shaped metal output shaft that matches the Pololu wheel 42x19mm and 32x7mm. The brass faceplate has two mounting holes threaded for M1.6 screws (1.6 mm diameter, 0.35 mm thread pitch), or you can use the mounting bracket or extended mounti..
19.33€
Ex Tax:15.40€
Brand: Sparkfun
Model: PRT14299
Description: This is a unique two-cell AA battery holder built specifically for the BBC micro:bit. The 6" (~150mm) cable has been terminated with a JST-PH connector. The connector mates the JST socket on the micro:bit perfectly, allowing you to easily make your project battery powered.
Note: Plea..
1.97€
Ex Tax:1.57€
Showing 1 to 7 of 7 (1 Pages)