Brand: Pololu
Model: POLO/2170
This 3-wire harness can be used to add a toggle switch between any two devices that can be connected with “JR” style servo connectors. One side of the switch has a lead with a female connector, while the other side has two leads, one male and one female.
We sell two versions of this harness:
..
5.01€
Ex Tax:3.99€
Brand: Pololu
Model: POLO/2171
This 18" (45 cm) harness has an inline on/off switch, with a 0.1" 3-pin female connector on one end and both a male and a female connector on the other.
This 3-wire harness can be used to add a toggle switch between any two devices that can be connected with “JR” style servo connectors. One side ..
6.02€
Ex Tax:4.80€
Brand: Pololu
Model: POLO/788
This 12-inch (300-mm) Y-cable has “JR” style connectors on all ends and is typically used to connect two servos to one servo port. As such, it has a single female and two male connectors (though in the RC hobby industry female connectors are often referred to as “male” and vice versa)...
7.03€
Ex Tax:5.60€
Brand: DFRobot
Model: FIT0005
Introduction
This mounting bracket is designed for Sharp GP2D12/2D15.
The color of bracket may vary and not the same as shown in the picture.
Specification
Size:45x20x15mm
Mounting hole distance:14mm
Weight:5g..
8.10€
Ex Tax:6.45€
Brand: Sharp Microelectronics
Model: POLO/136
Overview
The Sharp distance sensors are a popular choice for many projects that require accurate distance measurements. This IR sensor is more economical than sonar rangefinders, yet it provides much better performance than other IR alternatives. Interfacing to most microcontrollers is straightfo..
19.23€
Ex Tax:15.32€
Brand: Olimex
Model: SHIELD-LCD16x2
Description: Arduino compatible Serial / I2C LCD shield with LCD16x2 with backlight and 4 buttons, Arduino library and demo examples. Accepts commands by UART or I2C.
Documents: Here..
20.14€
Ex Tax:16.05€
Brand: DFRobot
Model: TOY0054
Introduction: The Si7021 I2C Humidity and Temperature Sensor is a monolithic CMOS IC integrating humidity and temperature sensor elements, an analog-to-digital converter, signal processing, calibration data, and an I2C Interface. The patented use of industry-standard, low-K polymeric dielectrics for..
19.13€
Ex Tax:15.24€
Brand: Seeedstudio
Model: 110060025
The Arduino Sidekick Basic Kit is designed to be used with your Arduino / Seeeduino / Seeeduino ADK / Maple Lilypad or any MCU board. It contains everything needed for a first-time user to connect his/her computer to an Arduino. It includes many of the most popular accessories for DIY projects : lik..
30.26€
Ex Tax:24.11€
Brand: Pololu
Model: POLO/1372
The Pololu Simple Controller 18v7 makes basic control of brushed DC motors easy, with our free Simple Motor Control Center software enabling quick configuration over USB. The controller supports four interface modes: USB, TTL serial, analog voltage, and hobby radio control (RC). This version operate..
171.96€
Ex Tax:137.02€
Brand: Sparkfun
Model: SEN09332
Description: Breakout board for the low power, single axis ADXL193 accelerometer. The ADXL193 is a high-g sensor with a full scale range of..
34.31€
Ex Tax:27.34€
Brand: Sparkfun
Model: COM10976
Description: These motorized sliders are very cool. Each is essentially a standard slide pot which is belt-driven by a small motor. The slide contains two separate 10k linear taper potentiometers so that you can use one as servo-feedback in order to read the position of the slider and use the other ..
22.16€
Ex Tax:17.66€
Brand: SpringRC
Model: ROB10189
Here, for all your mechatronic needs, is a simple, high quality continuous rotation servo motor. This servo is able to take in 6 volts and deliver 30.6 oz-in. of maximum torque at 0.14 sec/60°
A standard 3-pin power and control cable is attached and all hardware listed below is included.
1x..
15.08€
Ex Tax:12.02€