Brand: Pololu
Model: POLO/1481+1479
This semiconductor gas sensor detects the presence of LPG, isobutane, and propane at concentrations from 300 to 10,000 ppm. The sensor’s simple analog voltage interface requires only one analog input pin from your microcontroller.
Shipping list: 1 x LPG / Isobutane / Propane Gas Sensor MQ-6, 1 x ..
8.10€
Ex Tax:6.45€
Brand: Pololu
Model: POLO/2127
Description: The LSM303D combines a digital 3-axis accelerometer and 3-axis magnetometer into a single package that is ideal for making a tilt-compensated compass. The six independent readings, whose sensitivities can be set in the ranges of ±2 to ±16 g and ±2 to ±12 gauss, are available through I²C..
12.04€
Ex Tax:9.60€
Brand: Sparkfun
Model: SEN10888
Description: The LSM303DLMTR is a triple axis accelerometer combined with a triple axis magnetic sensor. This arrangement allows for the LSM303 to perform 6D orientation detection. This breakout board uses the LSM303DLMTR to give you all the data you need to feed into a microcontroller and calculate..
33.65€
Ex Tax:26.81€
Brand: Sparkfun
Model: SEN12636
Description: This is the LSM9DS0, a versatile motion-sensing system-in-a-chip that houses a 3-axis accelerometer, 3-axis gyroscope, and 3-axis magnetometer. That's right, 9 degrees of freedom (9dof) from a single IC!
Each sensor in the LSM9DS0 supports a wide range of, well, ranges: the accelerom..
33.30€
Ex Tax:26.53€
Brand: Robomaa.com
Model: RM-115
Description: Nylon short standoffs - M3 x 10 Hexagonal Standoff - 10 Set. Used to get your proto board up off the table...
4.00€
Ex Tax:3.19€
Brand: Robomaa.com
Model: RM-114
Description: Suitable for all kinds of circuit boards, sensors, mechanical support of the installation.
Specifications:
Hexagonal standoffs length: 10 mm
Material: Nylon
Shipping List:
M3 x 10 hexagonal standoffs (10 units)
M3 x 5 screws (10 units)
M3 nuts (10 units)..
6.02€
Ex Tax:4.80€
Brand: Pololu
Model: POLO/1931
These male pins can be crimped on 22-28AWG wires and snapped into our crimp connector housings to create custom cables that are compatible with standard 0.1"-pitch headers and solderless breadboards. Our wires with pre-crimped terminals use these same pins. One male crimp pin pack consists of 100 pi..
14.68€
Ex Tax:11.69€
Brand: Devantech
Model: MD04
Description: The MD04 is a medium power motor driver and is an upgraded replacement for the MD03, the main features are ease of use and flexibility. The motor's power is controlled by on-board Pulse Width Modulation (PWM) generators driving the H-Bridge Transistors. Voltage - 8v - 24v Current - up t..
65.69€
Ex Tax:52.34€
Brand: DFRobot
Model: DFR0035
Introduction
The MEGA IO Expansion Shield can be used for a variety of interactive works, it is often used in a number of sensors or circuit. For those who are familiar with the electronic circuits or universal board with bread board module, it helps in building a simple circuit effortlessly, but..
16.19€
Ex Tax:12.90€
Brand: Sparkfun
Model: DEV11007
Description: It's powerful, it's portable, it's Pro! We're continuing our Pro series of Arduino-compatible micro-controllers with the addition of the Mega Pro. This is a 5V microcontroller running a version of the stk500v2 bootloader at 16MHz. Just like the other Pro-series boards this board is buil..
54.15€
Ex Tax:43.15€
Brand: DFRobot
Model: DFR0016
Introduction
This is a design for an open-source prototyping shield for Arduino Mega. It has tons of cool features, to make prototyping on your Arduino easy. Assembly and soldering is required!
Features:
Reset button up top
Lots of GND and +5V rails
DIP prototyping area makes it easy..
12.04€
Ex Tax:9.60€