Menu
Your Cart
Welcome to the new Robomaa online store!

All Products

Brand: Microbot Model: MR103-007
Description: These Linear Actuators are designed for most metal and the entire casing is sealed to provide protection against dust and water vapor: the manufacturer provides a degree of protection IP54. They use a worm drive to move a shaft back and forth along its length. The worm drive ensures ..
122.36€
Ex Tax:97.50€
Brand: Microbot Model: MR103-003
Description: These Linear Actuators are designed for most metal and the entire casing is sealed to provide protection against dust and water vapor: the manufacturer provides a degree of protection IP54. They use a worm drive to move a shaft back and forth along its length. The worm drive ensures th..
111.23€
Ex Tax:88.63€
Brand: Robotis Model: 903-0143-000
DESCRIPTION This Li-Po battery is intended for the Bioloid Premium Kit. PCM embedded to protect from over charge, over discharge, and excess current. INCLUDES LIPO 11.1V Battery Set LBS-10 : 1 pc Battery Cover : 1 spc F60 : 1 pc CABLE-BAT : 1 pc H/W SPECIFICATION Volt..
34.61€
Ex Tax:27.58€
Brand: Robotis Model: 903-0144-000
DESCRIPTION This charger is intended for the Li-Po battery in the Bioloid Premium Kit. Uses the SMPS for power when charging, thus it must be accompanied with the SMPS 12V 5A. Support 2S and 3S Cell charge. (Exception, does not charge simultaneously) INCLUDES: LIPO Battery Charger LBC-10..
24.29€
Ex Tax:19.35€
Brand: Sparkfun Model: PRT10217
Description: If you need to charge LiPo batteries, this simple charger will do just that, and do it fast! The LiPo Charger Basic is stripped down of all features and just does one thing well - charge 3.7V LiPo cells at a rate of 500mA per hour. It is designed to charge single-cell Li-Ion or Li-Polym..
11.03€
Ex Tax:8.79€
Brand: Sparkfun Model: DEV10711
Description: Is there anything an Arduino can't do? Well, for one, most of them can't be powered directly from a 3.7V LiPo battery; much less charge and monitor that battery. The LiPower Shield takes care of this by combining the functionality of two of our favorite battery power boards: the Power C..
10,119.96€
Ex Tax:8,063.71€
Brand: DFRobot Model: DFR0023
Introduction: The DFRobot LM35 Linear Temperature Sensor is based on the semiconductor LM35 temperature sensor. The DFRobot LM35 Linear Temperature Sensor can be used to detect ambient air temperature. The LM35 chip is produced by National Semiconductor Corporation and offers a functional range betw..
7.08€
Ex Tax:5.65€
Brand: Sparkfun Model: SEN10245
Description: This load sensor is the same one found in digital bathroom scales (you know, the ones you use in January for your New Year’s resolutions, and then forget about a month later). This sensor can measure up to about 110 pounds. Check the video below for a simple explanation on how these wor..
13.06€
Ex Tax:10.40€
Brand: Olimex Model: OL-LOL10W-KIT
Description: Lots of Led shields with SMT, 3MM, 5MM, 10MM Leds available in 4 colours: RED, GREEN, BLUE and WHITE This is Lot-Of-Leds multiplexing LEDs shield with 126 LEDs made in 14x9 matrix. This shield originally was developed by Jimmie P Rodgers and you can find his original project and Ardu..
27.73€
Ex Tax:22.10€
Brand: Olimex Model: OL-LOL3R-KIT
Description: Lots of Led shields with SMT, 3MM, 5MM, 10MM Leds available in 4 colours: RED, GREEN, BLUE and WHITE This is Lot-Of-Leds multiplexing LEDs shield with 126 LEDs made in 14x9 matrix. This shield originally was developed by Jimmie P Rodgers and you can find his original project and Ardu..
20.14€
Ex Tax:16.05€
Brand: Olimex Model: OL-LOL3W-KIT
Description: Lots of Led shields with SMT, 3MM, 5MM, 10MM Leds available in 4 colours: RED, GREEN, BLUE and WHITE This is Lot-Of-Leds multiplexing LEDs shield with 126 LEDs made in 14x9 matrix. This shield originally was developed by Jimmie P Rodgers and you can find his original project and Ardu..
20.14€
Ex Tax:16.05€
Brand: Olimex Model: OL-LOL5W-KIT
Description: Lots of Led shields with SMT, 3MM, 5MM, 10MM Leds available in 4 colours: RED, GREEN, BLUE and WHITE This is Lot-Of-Leds multiplexing LEDs shield with 126 LEDs made in 14x9 matrix. This shield originally was developed by Jimmie P Rodgers and you can find his original project and Ardu..
22.97€
Ex Tax:18.31€
Showing 397 to 408 of 1573 (132 Pages)
Cookies
We use cookies to improve your browsing experience and the functionality of our site. These cookies are required for the website to run and cannot be switched off. Such cookie are only set in response to actions made by you such as language (En/Fi), currency (EUR) and login session id which is set by system (OCSESSID). You can set your browser to block these cookies but our site may not work then. Google Analytics (GA4) cookies allow us to measure visitors traffic and see traffic sources by collecting information in data sets. They also help us understand which products and actions are more popular than others. We do not share these information with Google.