Brand: Devantech
Model: ETH484C
ETH484 case. Includes mounting holes for fixing to a wall or back panel. This precision snap together case includes screws for mounting the ETH484 module.
Supplied as a case only, the ETH484 module should be ordered separately...
30.26€
Ex Tax:24.11€
Brand: Devantech
Model: ETH8020
Description: Controlled over Ethernet using simple TCP/IP commands.
The ETH8020 provides 20 volt free contact relay outputs with a current rating of up to 16Amp each and 8 analogue inputs. The module is powered from a 12vdc supply which can be regulated or unregulated. The DC input jack is 2.1mm ..
186.12€
Ex Tax:148.31€
Brand: DFRobot
Model: DFR0125
INTRODUCTION: The DFRduino Ethernet Shield V2.1 is now released. This version of Ethernet Shield is not only compatible with Mega 1280 and 2560, but also provides a Micro SD card slot for reading/writing.
DFRduino Ethernet Shield V2.1 is fully compatible with Ardunio Ethernet Shield. With the off..
20.14€
Ex Tax:16.05€
Brand: Sparkfun
Model: WRL10663
Description: This is an evaluation board for the Silicon Laboratories Si4703 FM tuner chip. Beyond being a simple FM radio, the Si4703 is also capable of detecting and processing both Radio Data Service (RDS) and Radio Broadcast Data Service (RBDS) information. The Si4703 even does a very good job o..
24.49€
Ex Tax:19.52€
Brand: Raspberry Pi
Model: RPi-NFC
Description: EXPLORE-NFC is a high performance full NFC expansion board for the Raspberry Pi. Based on the NXP PN512 solution, EXPLORE-NFC meets compliance with Reader mode, P2P mode and Card emulation standards. The board features an integrated high performance antenna and offers a flexible SPI int..
33.35€
Ex Tax:26.57€
Brand: Pololu
Model: POLO/1930
These female pins can be crimped on 22-28AWG wires and snapped into our crimp connector housings to create custom cables that are compatible with standard 0.1"-pitch headers and solderless breadboards. Our wires with pre-crimped terminals use these same pins. One female crimp pin pack consists of 10..
10.02€
Ex Tax:7.98€
Brand: Sparkfun
Model: PRT11269
Description: This pack of female headers includes two 6-pin headers and two 8-pin headers. This is similar to the header kit that comes with Arduino shields except that the pins are shorter so they don't stack. These are useful for Arduino compatible boards that don't come with headers already insta..
2.23€
Ex Tax:1.77€
Brand: Pololu
Model: POLO/1020
This connector is a single-row, 10-pin, straight female header strip designed to match 0.1" male headers...
0.56€
Ex Tax:0.44€
Brand: Pololu
Model: POLO/1012
This connector is a single-row, 2-pin, straight female header strip designed to match 0.1" male headers...
0.56€
Ex Tax:0.44€
Brand: Pololu
Model: POLO/1013
This connector is a single-row, 3-pin, straight female header strip designed to match 0.1" male headers...
0.56€
Ex Tax:0.44€
Brand: Pololu
Model: POLO/1014
This connector is a single-row, 4-pin, straight female header strip designed to match 0.1" male headers...
0.56€
Ex Tax:0.44€