Brand: Sparkfun
Model: KIT14051
Description: The SparkFun Wireless Joystick Kit provides an easy way to control your next XBee project. Before the wireless joystick, radio-controlled projects used hobby RC transmitters, the same ones used for RC cars, boats and planes. The problem with these transmitters is that many aren’t custom..
43.42€
Ex Tax:34.60€
Brand: Sparkfun
Model: KIT15936
Description: This is the SparkFun XBee 3 Wireless Kit, the perfect box full of goodies to get you started using XBees. Inside this kit you will find two XBee 3 Modules, one XBee Explorer, one Xbee Shield and a set of Arduino R3 headers to solder onto the shield. Our entire goal for the XBee Kit was ..
111.23€
Ex Tax:88.63€
Brand: Sparkfun
Model: COM11089
Description: This through-hole speaker is great for projects where you need something that sounds better than a piezo buzzer but don't have room for a full-blown speaker. This 30mm diameter speaker is encased in plastic and will handle about 100mW of power.
Features:
8 ohm0.1W (0.2..
3.54€
Ex Tax:2.82€
Brand: Sparkfun
Model: SEN13835
Description: The SST Liquid Level Sensor provides single point liquid detection via a TTL compatible push/pull output. This optical liquid level sensor features a miniature design that allows for installation in areas where space is limited. Thanks to its minimal solid state design, this sensor has ..
34.31€
Ex Tax:27.34€
Brand: Olimex
Model: OL-MOD-LED8x8
Description: MOD-LED8x8 is a LED stackable matrix which allows you to make a LED array display of any size by stacking a couple of them (snap-on) together. It stacks with a MSP430-LED8x8-BOOSTERPACK which controls it and with additional MOD-LED8x8 you can make a LED array display of any size which t..
9.01€
Ex Tax:7.18€
Brand: Olimex
Model: OL-17HS4023
Description: Stepper Motor - NEMA 17HS4023
HARDWARE:
Shaft diameter 5mm
Shaft Length 21mm
4 wires / 2 Phase
Voltage: 12 V
Current: 0.7 A / Phase
Resistance: 4.0 ± 10% Ω / Phase
Inductance: 3.2 ± 20% mH / Phase
Holding Torque: 14 N. cm
Insulation Class: B
Step Angle: 1.8 ± ..
16.09€
Ex Tax:12.82€
Brand: Olimex
Model: OL-42HB34F08AB
Description: Stepper Motor - NEMA 42HB34F08AB (17HS3401)
HARDWARE:
Shaft diameter 5mm
Shaft Length 21mm
4 wires / 2 Phase
Voltage: 12 V
Current: 1.33 A / Phase
Resistance: 2.2 ± 10% Ω / Phase
Inductance: 2.5 ± 20% mH / Phase
Holding Torque: 22 N. cm
Insulation Class: B
Ste..
16.09€
Ex Tax:12.82€
Brand: Waveshare
Model: W15948
Description: SM24240, Two-Phase Stepper Motor
Specifications:
Category: two-phase stepper motor
Step angle: 1.8°
Body length: 40mm
Rated current: 1.7A/Phase
Phase resistance: 2.4Ω
Phase inductance: 3.7mH
Holding torque: 0.45N.m
Rotor inertia: 54(g.c㎡)
Weight: 0.3kg
Wiring:..
14.07€
Ex Tax:11.21€
Brand: Waveshare
Model: W15669
Description: This Stepper Motor HAT gives your Raspberry Pi the ability to drives two stepper motors at the same time, supports up to 1/32 microstepping.
Features:
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
Onboard dual DRV8825 moto..
35.32€
Ex Tax:28.15€
Brand: Pololu
Model: POLO/1207
Description: This hybrid bipolar stepping motor has a 1.8° step angle (200 steps/revolution). Each phase draws 280 mA at 7.4 V, allowing for a holding torque of 650 g-cm (9 oz-in). The motor has four color-coded wires terminated with bare leads: black and green connect to one coil; red and blue conn..
28.25€
Ex Tax:22.51€
New
Brand: Pololu
Model: POLO/2267
This hybrid bipolar stepping motor has a 1.8° step angle (200 steps/revolution). Each phase draws 1.7 A at 2.8 V, allowing for a holding torque of 3.7 kg-cm (51 oz-in). The motor has four color-coded wires terminated with bare leads: black and green connect to one coil; red and blue connect to the o..
31.80€
Ex Tax:25.34€
New
Brand: Pololu
Model: POLO/2640
This is a spool with 50 feet (~15 m) of black 22 AWG stranded copper hook-up wire. Stranded wire is more flexible than solid wire and is good for
projects where you need the wire to be able to bend. The strands are
made of copper, and they might be tinned, which makes them look silver..
13.95€
Ex Tax:11.12€