Brand: Sparkfun
Model: DEV17244
Description: Discover the power of AI and robotics with NVIDIA® Jetson Nano™ 2GB Developer Kit with a more economical price aiming to deliver the performance to run modern AI workloads using the entire GPU-accelerated NVIDIA software stack in a small form factor to even more educators, students, dev..
10,119.96€
Ex Tax:8,063.71€
New
Brand: Sparkfun
Model: SEN14049
The MAX31820 ambient temperature sensor provides
9-bit to 12-bit Celsius temperature measurements with ±0.5°C accuracy
over a +10°C to +45°C temperature range. Over its entire -55°C to +125°C
operating range, the device has ±2.0°C accuracy.
The device communicates over a one-wire bus that, ..
8.00€
Ex Tax:6.37€
Brand: Sparkfun
Model: WRL14212
Description: The Electron is a tiny development kit for creating 3G cellular-connected electronics projects and products. It comes with a Particle SIM card with service in more than 100 countries worldwide, and includes 3 months of Particle's 1MB monthly data plan for IoT devices.
The E..
101.11€
Ex Tax:80.56€
Brand: Sparkfun
Model: WRL13764
Description: Particle’s IoT (Internet of Things) hardware development board, the Photon, provides everything you need to build a connected project. Particle has combined a powerful 120Mhz ARM Cortex M3 micro-controller with a Broadcom Wi-Fi chip in a tiny thumbnail-sized module called the PØ (P-Zero..
30.26€
Ex Tax:24.11€
Brand: Sparkfun
Model: KIT14526
Description: The Pi Zero USB Stem is a PCB kit that turns a Raspberry Pi Zero into a USB dongle. Once the Stem is installed, your Raspberry Pi can be plugged directly into a computer or USB hub without any additional cables or power supplies. The Raspberry Pi then acts as a USB device using its own ..
10,119.96€
Ex Tax:8,063.71€
Brand: Sparkfun
Model: COM13705
Description: The PicoBuck LED Driver is an economical and easy to use driver that will allow you to control and blend three different LEDs on three different channels. By default, each channel is driven at 330mA; that current can be reduced by either presenting an analog voltage or a PWM signal to t..
24.80€
Ex Tax:19.76€
Brand: Sparkfun
Model: DEV13614
Description: The Qduino Mini is a tiny, Arduino-compatible board with a battery connector and charger built-in as well as a fuel gauge that can tell you when to charge the battery! This little guy is super small, inexpensive, and is perfect to embed in your electronics projects. The Qduino Mini is t..
30.33€
Ex Tax:24.17€
Brand: Sparkfun
Model: PRT14427
Description: This is a 100mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but can be used for other applications as well.
Each Qwiic Cable's wires have been color coded to Red, Black, Blue, and Yellow.
The SparkFun Qwiic connect ..
2.13€
Ex Tax:1.69€
Brand: Sparkfun
Model: PRT14429
Description: This is a 50mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but can be used for other applications as well.
Each Qwiic Cable's wires have been color coded to red, black, blue and yellow.
This cable is used for connecti..
2.94€
Ex Tax:2.34€
Brand: Sparkfun
Model: DEV21802
Description: The Raspberry Pi Debug Probe is an inexpensive, all-in-one USB to serial debug and UART bridge. It provides the necessary hardware and cabling to support “plug and play” debugging of Raspberry Pi Pico and other microcontroller and microprocessor-based platforms.
The Raspberry Pi Debug ..
20.14€
Ex Tax:16.05€
Brand: Sparkfun
Model: PRT14017
Description: This 2x20 “tall” header has the same number and spacing of pins as a Raspberry Pi and provides your board with the ability to extend the heights of your GPIO to accommodate for enclosures or other parts that can encapsulate your Pi. This through-hole header has 40 0.1"-spaced pins and c..
2.73€
Ex Tax:2.18€
Brand: Sparkfun
Model: SEN11862
RFID (radio-frequency identification) is the wireless
non-contact use of radio-frequency electromagnetic fields, for the
purposes of identifying and tracking tags attached to objects. This is
the ID-3LA, a very simple to use RFID reader module from ID Innovations.
The only holdups are the 2m..
37.35€
Ex Tax:29.76€