Brand: Sparkfun
Model: PRT10967
Description: The NCP1402 is a 3.3V DC-DC converter. The breakout board will accept voltage inputs between 1 and 3 Volts (such as 1 or 2 AA batteries) and output a constant, low ripple 3.3V output capable of sourcing up to 200 mA. This board is great for supplying power to 3.3V sensors or providing 3..
7.08€
Ex Tax:5.65€
Brand: Sparkfun
Model: DEV11608
Description: The Netduino Plus is an open source electronics platform using the .NET Micro Framework. The board features a 32-bit microcontroller and a rich development environment, making it a perfect solution for engineers and hobbyists alike.
The Netduino Plus 2 has four times the speed (168MH..
79.96€
Ex Tax:63.71€
Brand: Sparkfun
Model: SEN11005
Description: This non-invasive current sensor (also known as a "split core current transformer") can be clamped around the supply line of an electrical load to tell you how much current is passing through it. It does this by acting as an inductor and responding to the magnetic field around a current..
15.08€
Ex Tax:12.02€
Brand: Sparkfun
Model: CAB10087
Description: Once you've hacked everything, why not go out in the garage and hack your car? This cable allows you to access the pins on your car's OBDII connector. It has an OBDII connector on one end and a DB9 female serial connector on the other. The overall length of the cable is 5' (1.5m).
No..
14.07€
Ex Tax:11.21€
Brand: Sparkfun
Model: WIG09555
Description: This board allows you to interface with your car's OBD-II bus. It provides you a serial interface using the ELM327 command set and supports all major OBD-II standards such as CAN and JBUS. The board also provides a footprint which mates directly to our FTDI Basic or a Bluetooth Mate. Th..
58.20€
Ex Tax:46.37€
Brand: Sparkfun
Model: COM11644
Description: OpenSegment makes it easy to add a large 7-segment display to your project. Because larger 7-segment displays pull more power than a microcontroller is able to drive directly, the OpenSegment has 8 PNP and 4 NPN transistors in order to drive the segments at their maximum brightness!
..
19.94€
Ex Tax:15.89€
Brand: Sparkfun
Model: COM11648
Description: OpenSegment makes it easy to add a large 7-segment display to your project. Because larger 7-segment displays pull more power than a microcontroller is able to drive directly, the OpenSegment has 8 PNP and 4 NPN transistors in order to drive the segments at their maximum brightness!
..
19.94€
Ex Tax:15.89€
Brand: Sparkfun
Model: ROB09014
Description: This is our version of the OpenServo open-source servo controller board. It's meant to replace the existing controller board in any standard servo (~.78 inch servo width). With this board you can control a servo entirely with I2C/TWI commands rather than PWM, meaning that multiple OpenS..
18.32€
Ex Tax:14.60€
Brand: Sparkfun
Model: CAB10759
Description: Integrating Ethernet support into your project is a great way to relay data through a local area network and even bounce information out to the internet. Sometimes it's hard to get power to your Ethernet devices. Wouldn't it be convenient to use the same cable for power and data? Using ..
6.98€
Ex Tax:5.56€
Brand: Sparkfun
Model: KIT13091
Description: This is the SparkFun Pi Wedge B+, a small board that connects to the 40-pin GPIO connector on the Raspberry Pi B+, and breaks the pins out to breadboard-friendly arrangement and spacing, and even adds a couple of decoupling capacitors on the power supply lines. The “Wedge” also makes th..
10,119.96€
Ex Tax:8,063.71€
Brand: Sparkfun
Model: SEN13285
Description: This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the ‘alarm’ pin will go low.
This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire ..
13.06€
Ex Tax:10.40€
Brand: Sparkfun
Model: PGM09825
Description: This version uses an SMD 5x2 header. This is a simple to use USB AVR programmer. It is low cost, easy to use, works great with AVRDude, and is tested extensively on a Windows desktop. Based on Dick Steefland's USBtiny and Limor Fried's USBtinyISP.
We've gotten a big response from Mac..
25.20€
Ex Tax:20.08€