INTRODUCTION: This is the most powerful standard servo sized motor from DFRobot so far. The DF15RSMG equips with two pairs of the servo shells. One is a stardard shell with four M4 mounting holes. And the other one includes a shell with double bearing which is specially designed for the application of the robot arm or the joints.The shells of this kit are thickened to make it stable enough for motion system.
The torque of this motor is about 19kg.cm at 7.4v power supply.Using the Arduino servo library, you could drive this servo motor easily.To reduce the consumption of your microcontroller, this servo has a lock function for the pulse detection. So driving it to a target position just requires one PPM controlling signal.
NOTE: This Servo Motor is not a servo which allows you control position, but it is actually a motor with servo appearance. You could use servo.h to make adjust its speed and rotation direction. For more, you could find it in Comment below.
- Brown - GND
- Red - VCC
- Orange - Signal(PPM input wire)
- Rotation angle range: 360°
- No-load speed:60°/0.16s @7.4v
- Stall torque:19.3kg.cm（7.4v）
- Dynamic torque:15.1kg.cm（7.4v）
- Gear:steel,copper mixed gear
- Assembly method:fastening with double layer 4 screws
- Equip 2 pairs of shells,2 metal servo horns and 2 servo support
- Size: 40x40x20mm (1.57x1.57x0.79")
- Working Voltage: 5-7.4v
- Stall current:3A(@8.5V - Limit test)
- PPM Voltage:3V-5V
- PPM Resolution:2us
- PWM driver frequency:4KHZ
- Range of PPM positive pulse width:400us-2550us
- Minimum value of PPM negative pulse width:400us
HUOM: HTML-koodia ei käännetä!
Arvio: Huono Hyvä
Kirjoita kuvassa näkyvä varmistuskoodi: